Dual In-Line MemoryModulesOptions 5-1313 Reattach the left side cover.14 Plug the printer in and turn it on.» Note:In compliance with UL guidelines, “The appliance inlet is considered to bethe main disconnect device.”Dual In-Line Memory ModulesYour magicolor 6100 DeskLaser comes with 32 MB RAM. However, you can upgrade itto a maximum of 256 MB of RAM through the installation of additional DIMMs (Dualin-line memory modules, compact circuit boards with surface-mount memory chips).Additional memory must be 32, 64, 128, or 256 MB PC-100 Compliant SDRAM DIMMs.Additional memory allows you to increase the printer's buffer (the area where datasent from the computer is stored while waiting to be printed).» Note:You may need additional memory to print on some media sizes at 1200x600dpi. See “Minimum System Memory Requirements,” in chapter 4, “Advanced PrinterOperations.” Caution:If both memory connectors (DIMM0 and DIMM1) are used, they may containonly 64 MB DIMMs. The second memory connector (DIMM1) cannot be used if a 32,128, or 256 MB DIMM is installed in the first memory connector (DIMM0). Using anyother memory configuration may prevent the printer from booting.Installation ProcedureBefore attempting to install or remove memory from your printer, carefully review thefollowing information concerning antistatic protection.Antistatic Protection Caution:It's very important to protect the printer controller board and any associateddaughterboard or module from electrostatic damage while performing any taskinvolving the controller board.
