IPDS User Guide 2- 11Installation and Setupserver Queue Manager. This print queue initially has anAccept value of Yes and a Release value of Yes.• Ensure that no overrides are set on the queue for any of theproperties defined earlier in this section.• Ensure the IPS Manager has the streaming queue selected aspart of the active Job Profile.To verify that the installation and initial setup are successful, printa host job and either the US Letter or the A4 sample job. If bothprint successfully, installation verification is complete.NOTE: It is important to be aware that you should never submit anIPDS job to a paused print server. IPDS jobs will hang when theyare submitted to a system in a paused state. This is normalbehavior for IPDS jobs; while all other PDL types can RIP and waitfor the printer, IPDS jobs cannot.In addition, if you installed the IBM® AFP resident outline fonts,print the scfont.trc sample job to verify that the fonts were loadedcorrectly.Printing a Trace Job Within IPS ManagerDuring the installation process, six sample Xerox FreeFlow® PrintServer IPDS trace jobs are provided. These jobs can be used toeither verify printer operability after the Xerox FreeFlow® PrintServer IPDS software is installed or for diagnostic purposes:• afptrace.let — prints a sample IPDS job formatted for USLetter paper• afptrace.a4— prints a sample IPDS job formatted for A4 paper• scfont.trc— prints a sample IPDS job using resident outlinefonts formatted for either US Letter or A4 paper.• micrtrace.letter — prints a sample IPDS Magnetic InkCharacter Recognition (MICR) job formatted for US Letterpaper• micrtrace.a4 — prints a sample IPDS MICR job formatted forA4 paper• micrtrace.legal— prints a sample IPDS MICR job formatted forUS Legal paperIn order for the trace scfont.trc to print correctly, the IBM® AFPfonts must be loaded on the printer and Enhanced Font Supportmust be enabled.NOTE: These jobs test only Xerox FreeFlow® Print Server IPDSprocessing on the printer.The trace files are set up to use the installation defaultparameters. If you plan to run the A4 trace instead of the USLetter trace, change the Media Definition for the Xerox FreeFlow®