40 Phaser 6200 Color Laser Printer - Service ManualMisfeed at Tray 1 Jam T1The printers front panel displays ìMisfeed at Tray 1î indicating a paper misfeed hasoccurred in the printer. Tray 1 is free from defects and installed properly. Anyobstruction, media and debris has been removed from the paper path and there isadequate paper in the paper tray. Printer power has been cycled and the error stilldisplays.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map ReferencesPaper Pick Roller Kit, PL 3.3.3 "Paper Tray 1" on page 354Paper Feed Roller Kit, PL 3.3.23 "Paper Feed" on page 362Paper Pick Assembly, PL 3.3.1 "Drive Section" on page 355Chute Assembly Registration, PL 9.1.6 "Main Wiring Diagram" on page 352Steps Actions and Questions Yes No1 Check the following parts for fault ordamage:Check for worn or damaged rollers andgears on the Paper Pick Assembly andthe Feed Roller on Tray 1.Check Tray 1 for damage.Remove any foriegn objects or debris inthe paper path.Registration Sensor PL 9.1.8Main Drive Assembly PL 11.1.14Replace anydamaged orexcessively wornparts.Go to step [2].2 Use service diagnostics to test theRegistration Sensor.Does the sensor function normally?Go to step [6]. Go to step [3].3 Check that the connection between theHarness and the Registration Sensor isproperly connected and seated.Go to step [4]. Connect orreplace thefaulty part.4 Check the Registration Clutch Harnessfor continuity.See "Paper Feed" on page 362Go to step [5]. Replace theRegistrationChuteAssembly,RRP 9.3.5 Is the voltage between P/J18-3 <=>P/J18-2, located under the electrichousing assembly (see RRP 9.3) on theEngine Control Board is 0 VDC.ReplaceRegistrationSensor, RRP 9.4.Go to step [6].6 If possible, print a sheet of paper fromTray 1.Does the Main Drive Motor functionproperly?Go to step [16]. Go to step [7].
