4. Load and align the edge of the tab paper against the right edge of the tray in theLEF direction as shown in following illustration:5. Adjust the paper guides by pressing in the guide release and carefully moving theEdge Guide until it lightly touches the edge of the material in the tray.Do not load materials above the MAX line located on the rear Edge Guide.6. If necessary, set the skew adjustment levers to the desired position for your print job.7. Gently push in the tray until it comes to a stop.If enabled by your System Administrator, the Paper Tray settings screen may bedisplayed on the UI.8. If changes have been made to the paper tray, select the Change Settings button;otherwise, proceed to the next step.a) Make the desired selections for Paper Type/Paper Weight, Paper Size, and PaperColor.b) If necessary, make the desired changes to paper curl and alignment adjustment.NoteRefer to the System Administration Guide for detailed information on the papercurl and alignment adjustment options.c) Select Save until you are returned to the tray settings window.9. Select Confirm to close the window.10. For network print jobs, refer to your print server customer documentation forinstructions on loading tab stock into a tray.Loading transparencies in the OHCF (1 or 2 Trays)1. Select the appropriate paper stock for your print job.2. Pull out the tray slowly until it stops.3. Fan the transparencies to stop them from sticking together before loading into thetray.4. Load transparencies on top of a small stack of same-size paper and align the edgeof the transparency against the right edge of the as shown in following illustration:5. Adjust the paper guides by pressing in the guide release and carefully moving theEdge Guide until it lightly touches the edge of the material in the tray.18-5Xerox® D95/D110/D125/D136 Copier/PrinterUser GuideOversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
