Clearing jamsUse the following procedure to clear jams or faults and then resume printing:1. Follow the instructions displayed on the machine's UI.2. If instructed by the machine UI, open the Top Left Cover and the Top Right Coverof the SquareFold Trimmer Module.3. Look for any jammed booklets within the SquareFold Trimmer Module paper pathand remove them.4. Check for loose trim scraps along the paper path and remove them.5. Close the Top Left and Right Covers.6. Empty the Trimmer Waste Container.7. Ensure that the Trimmer Waste Container is completely pushed in/closed.8. Ensure that all covers on the SquareFold Trimmer Module are closed.9. If the SquareFold Trimmer Module Control Panel and/or the machine’s UI indicatethere is a still a jam, recheck the SquareFold Trimmer Module (steps 1-8).10. If necessary, open the finisher to look for jams/faults along the finisher path.11. Follow the instructions displayed on the machine UI to resume printing.Clearing E1/E2 jamsUse the following procedure to clear jams when the E1 and/or E2 LED is lit on theSquareFold Trimmer Module control panel.1. Make sure that the machine is not in operation, and press the button on the left coverof the Trimmer unit to open the cover.23-13Xerox® D95/D110/D125/D136 Copier/PrinterUser GuideSquareFold Trimmer Module
