DocuColor 240/250DocuColor 240/250 Training and Information Guide 154Replacing the Charge CorotronThis procedure shows you how to remove the used Charge Corotron and replacethe machine with a new Charge Corotron. The machine will tell you when youneed to order a new one and when to install it.CAUTION: Do not expose this item to direct sunlight or strong light from indoorfluorescent lighting. Image quality may deteriorate when these areexposed to light for more than two minutes.1. Make sure the machine has stopped running.2. Open the Front Door.3. Pull down the R1-R4 handle.4. Raise the Release Handle.5. Open the packaging for the new Charge Corotron and gently place the newCharge Corotron on a flat surface near the machine.6. Pull out the Drum Drawer.CAUTION: Remember to minimize the amount of time that the drum cartridgesare exposed to light. Exposure for more than two minutes mayresult in light shock to the drums.7. Grasp both of the Amber-Gold colored casings on the old Charge Corotronand push towards the back of the machine. You will hear a clicking noiseindicating that it is being released.8. Remove the old Charge Corotron by holding the finger rings provided at theboth ends of the Charge Corotron and gently pulling straight up.9. Gently lower the new Charge Corotron into the machine straight down, andnot at an angle.10. Grasp the Amber-Gold colored casings on the new Charge Corotron and pulltowards the front of the machine until you hear a clicking noise to indicate theCharge Corotron is in place.11. Push in the Drum Drawer completely. Return the Release Handle to itsoriginal position.CAUTION Remember to close the Drum Drawer - Do not expose drumcartridges to direct sunlight or strong light from indoor fluorescentlighting. Do not touch or scratch the surface of the drum. Doing somay result in unsatisfactory printing.12. Return the R1-R4 handle to the original position and close the front door.13. Insert the used Charge Corotron into an empty container for recycling.
