Xerox DocuPrint C2255 Quick Referenc Manual

Also see for DocuPrint C2255: User guide

Contents

Switching the Control Panel Display Language 23Switching the ControlPanel Display LanguageSet either [English], [Korean], [Simp. Chinese], or[Trad. Chinese] as the display language for thecontrol panel of the printer.The following explains how to switch the controlpanel display language.Note• This guide assumes that [Language] has been set to[English]. The following operations are unnecessary ifyou are using an English operating system.1. Press the button to display themenu screen.2. Press the < > button until [Language] isdisplayed.Note• If you went past the desired item, return to the item bypressing the < > button.3. Press either the < > or button toselect.The language is displayed.4. Press the < > button until the desiredlanguage is displayed.5. Press the button to confirm.6. Press the button to close the menu.The printer automatically restarts.Setting the NetworkEnvironmentThis section explains how to install your printer ina TCP/IP environment. When installing the printerin a different environment, refer to the ‘CD-ROMDocumentation (HTML)’ on the Driver CD Kit CD-ROM.Note• The printer can use an IPv6 address in an IPv6 networkenvironment. For information on using IPv6 addresses,refer to “Setting an IP Address (IPv6)” (P. 26).Setting an IP Address (IPv4)To use TCP/IP protocol, you must configure an IPaddress for the printer.By default, the printer is set to obtain its IPaddress (via the [Get IP Address] setting on thecontrol panel) using [DHCP/Autonet]. Thus, whenthe printer is connected to a network that has aDHCP server, the printer automatically obtains itsIP address from the server.Print the [Configuration Report] to see if the printeralready has an IP address.If the printer does not have an IP address, set [GetIP Address] to [STATIC] and configure theaddress.Note• For information on how to print the [ConfigurationReport], refer to “Printing a Report/List” (P. 36).• The printer can also obtain its IP address by using aBOOTP or RARP server. If using a BOOTP or RARPserver, set [Get IP Address] to [BOOTP] or [RARP].• If using a DHCP server, the printer’s IP address maychange without notice. Make sure to check the addressperiodically.MenuLanguageEmulationMenuLanguageLanguage•EnglishLanguage•KoreanIf an IP address is listed, skip thefollowing procedure.If an IP address is not listed, or ifyou want to change the current IPaddress, configure the settingusing the following procedure.