86 A Appendix6. Reinsert the control board back into theprinter. Holding its handle, slide the controlboard back into the printer.Press the control board in as far as it will go.7. Tighten the two screws to secure the controlboard in place.8. Connect the power cord to the printer.Press the <|> side of the printer's powerswitch to turn on the power.9. Print the [Configuration Report] and confirmthat the [Total Size] value of the [Memory]item in the [Print Service Settings] section iscorrect.Refer to• List printing procedure: “Printing a Report/List” (P. 36)The installation is now complete.Note• After installing additional memory, use the propertiesdialog box of the print driver to change the printerconfiguration. For details, refer to the online help for theprint driver.Installing the Hard DiskThe hard disk must be installed in any of thefollowing instances.• To enable the following featuresSample Set, Secure Print, E-mail Print, PrivateCharge Print, Delayed Print, Font Downloading,SMB folder, Feature Enhance Kit, IEEE802.1xauthentication, IPsec certificate• To enhance the following installed featuresNumber of forms that can be registered,electronic sort feature performance, spoolcapacity, number of log entriesThis section describes how to install the hard diskon the printer.1. Switch the power off by pressing the < >side of the power switch.2. Unplug the power cord from the power outletand the printer.Hard disk