8Radio Frequency EmissionsFCC regulationsThis device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:• This device may not cause harmful interference, and• This device must accept any interference received, including interference thatmay cause undesired operation.This device has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:1 Reposition the receiving antenna.2 Increase the separation between the equipment and receiver.3 Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.4 Consult the dealer or an experienced radio/TV technician for help.CAUTION: Changes or modifications not expressly approved by the manufacturerresponsible for compliance could void the user’s authority to operate the equipment.Canadian Radio Interference RegulationsThis digital apparatus does not exceed the Class B limits for radio noise emissionsfrom digital apparatus as set out in the interference-causing equipment standardentitled “Digital Apparatus”, ICES-003 of the Industry and Science Canada.Cet appareil numérique respecte les limites de bruits radioélectriques applicables auxappareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur:“Appareils Numériques”, ICES-003 éditée par l’Industrie et Sciences Canada.