09/20074-42 Phaser 8860/8860MFP Service ManualREP 2.0.22, REP 3.0.1Initial IssueRepairs and AdjustmentsREP 2.0.22 Preheater Lift SolenoidParts List on PL 2.0RemovalNOTE: These steps describe Preheater lift Solenoid removal for the 8860MFP. On 8860 mod-els, access the Preheater lift Solenoid by removing the Control Panel (REP 1.1.6). Afterwards,return to this procedure and begin at Step 3.1. Remove the Scanner Assembly and attached DADF (REP 1.0.11).2. Remove the Output Tray (REP 1.0.6).3. Remove the Left Side Cover (REP 1.0.7 or REP 1.1.9 for the 8860).4. Remove the Right Side Cover (REP 1.0.21 or REP 1.1.10 for the 8860).5. Remove the Upper Duplex Guide (REP 3.0.5).6. Remove the Outer Duplex Guide (REP 3.0.6).7. Disconnect the Preheater Solenoid (P/J202).8. Remove the screw that secures the solenoid to the Transfix Load Module.Figure 1 Removing the Preheater SolenoidREP 3.0.1 Inner Simplex GuideParts List on PL 3.0Removal1. Open the Front Door.2. Raise the Lower Duplex Guide.3. Pry inward on the 2 retainers to release them from the mounting post.4. Slide the guide down and forward to remove it from the chassis.Figure 1 Removing the Inner Simplex GuideReplacementPosition the fingers on the Inner Simplex Guide over the segmented roller. Install the guide bysnapping the left side to the retaining post, then the right side.
