09/20074-46 Phaser 8860/8860MFP Service ManualREP 3.0.6, REP 3.0.7Initial IssueRepairs and AdjustmentsREP 3.0.6 Outer Duplex GuideParts List on PL 3.0RemovalNOTE: These steps describe Outer Duplex Guide removal for the 8860MFP. On 8860 models,access the Outer Duplex Guide by removing the Control Panel (REP 1.1.6). Afterwards, returnto this procedure and begin at Step 2.1. Remove the Output Tray (REP 1.0.6).2. Remove the Left Side Cover (REP 1.0.7 or REP 1.1.9 for the 8860).3. Remove the Right Side Cover (REP 1.0.21 or REP 1.1.10 for the 8860).4. Disconnect the Front Door P/J140 and Exit Door P/J411 Interlock Switches on the8860MFP and remove the guide. For 8860 models, these connections are made on theControl Panel (Figure 12).5. Remove the 4 (plastic, T-20) screws that secure the Outer Duplex Guide.Figure 1 Removing the Outer Duplex GuideREP 3.0.7 Exit Module (8860MFP)Parts List on PL 3.0Removal1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).2. Remove the Output Tray (REP 1.0.6).3. Remove the Left Side Cover (REP 1.0.7).4. Remove the Right Side Cover (REP 1.0.21).5. Remove the Ink Loader (REP 2.0.1).6. Remove these components from the right side:a. Remove the right front (plastic, T-20) screw.b. Remove the KL-Clip, Pulley, and Belt from the Exit Elevator Roller to access andremove the right rear screw located behind the large Wiper Assembly gear.Figure 1 Exit Module Right Side Fasteners
