Network ConfigurationWorkCentre 6400 Multifunction PrinterSystem Administrator Guide295. Type a name up to 256 characters for the default TRAP Community Name or use the defaultvalue of SNMP_TRAP.Note: The Default TRAP community name is used to specify the default community name for alltraps generated by this printer. The Default TRAP community name can be overridden by theTRAP community name specified for each individual TRAP destination address. The TRAPcommunity name for one address may not be the same TRAP community name specified foranother address.6. Click Apply button to accept the changes or Undo to retain the previous settings.Editing SNMP v3 SettingsNotes:• An administrator account is required to access this feature even if the printer is set tounlocked. For details, see Accessing CentreWare IS on page 17.• Before SNMPv3 can be enabled, a digital certificate must be installed on the printer andSSL must be enabled. For more detail see Installing a Digital Certificate on page 62.1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP.2. Under SNMP Properties, click Edit SNMP v3 Properties.3. Under Administrator Account, click Account Enabled to create the administrator account.4. Type an Authentication Password then confirm it. This password is used to generate a key usedfor authentication.Note: The password must be at least 8 characters in length and can include any characters exceptcontrol characters.5. Type a Privacy Password and confirm it. The Privacy password is used for encryption of SNMPv3data. The passphrase used to encrypt the data needs to match with the Server.6. Under Print Drivers/Remote Clients Account, click Account Enabled.7. Click Save to accept the current settings or Undo to retain the previous settings.8. Click OK.SNMP Advanced SettingsAdding IP Trap Destination AddressesNote: If your printer is locked, you must log in as a system administrator. For details, see AccessingCentreWare IS on page 17.1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP.2. Click Advanced Settings at the bottom of the page.3. Under Trap Destination Addresses, click Add IP Address.
