Xerox WorkCentre 7335 System Administrator Manual

Also see for WorkCentre 7328: Quick use guide Quick use guide Copying guide Quick network setup guide Setup guide

Contents

Xerox WorkCentre 7335 System Administrator Manual Manual pdf 27 page image

15Port Status (SNMP Enablement)1. On the SNMP selection menu, press the selection line labeled Port Status.2. Press the Change Settings button.3. On the Port Status screen, note which of the two buttons is highlighted as the current setting for SNMPEnablement. The available settings are Enabled or Disabled. For SNMP to function, it must be set toEnabled.4. To change settings, press your setting of choice, then press the Save button.5. To exit the screen, without making any changes, press the Cancel button.Exiting the SNMP Selection MenuTo exit the SNMP selection menu, which returns you to the Port Settings menu, press the rectangularClose button in the upper right corner of the touch screen.Exiting the Port Settings Menu and returning to the Device's Tools tab screen6. To exit the Port Settings menu, returning to the Tools tab screen, press the rectangular Close button inthe upper right corner of the Port Settings menu screen.7. Wait several seconds and the Auto Clear service should log you out.Note: If you changed any settings in the Port Settings menu, the Device will automatically reboot toregister and enable your new settings.