Network Connectivity30 WorkCentre 7800 Series Multifunction PrinterSystem Administrator GuideConnecting to a Wireless NetworkIf the printer is connected to your wired network, you can configure wireless settings in CentreWareInternet Services.Note: You cannot connect to a wired network and a wireless network at the same time.Before you begin, purchase and install the Xerox ® Wireless Network Interface.1. In CentreWare Internet Services, click Properties > Connectivity > Setup.2. Next to Xerox ® Wireless Network Interface, click Edit.Note: The Edit button is available after you install the Xerox ® Wireless Network Interface.3. To configure IPv4, IPv6, and DNS settings, on the Wireless Profile page, next to IP, click Edit.Configure settings as needed, then click Apply. The printer uses separate IP settings for wired andwireless network connections. For details, see IP on page 33.4. On the Wireless Profile page, next to Wireless Settings, click Edit.5. On the Wireless Settings page, click Scan for Available Networks. A list of detected networksappears.6. Next to the SSID name of the network you want to join, click Configure and Select.7. The printer detects the security mode that your network uses. Configure the following security modesettings as needed:− Under WEP Setting and Key, select the bit strength and key.− Under Encryption Algorithm, select an encryption method. Auto automatically detects thealgorithm that your wireless network uses.− Under Authentication Method, select the authentication method that your wireless networkuses.− To require the printer to validate certificates, under Server Validation, select the certificate thatyou want to use. Install the validation server root certificate on the Security Certificates pageat Properties > Security > Security Certificates. For details, see Security Certificates onpage 102.− Under Device Certificate (TLS) - Authentication Certificate, select the device certificate thatyou want to use. Install the device certificate on the Security Certificates page at Properties >Security > Security Certificates. For details, see Security Certificates on page 102.− Under Outer Identity, configure the external User ID.− Under User Name, type the user name that the printer uses to access the wireless network.− Under Password, type and confirm a password. Click Select to save new password as needed.8. Click Save.9. Navigate back to the Setup page, then click Properties > Connectivity > Setup.10. Next to Xerox ® Wireless Network Interface, click Make Active.
