Xtender XTS 900-12 User Manual
                                                        | |
Contents
| 
Studer Innotec SAXtenderUser manual V4.6.0 3911 CONTROL11.1 MAIN ON/OFF CONTROLThis switch (1) interrupts the electronic supply andall the Xtender peripherals. The residualconsumption on the battery is therefore less than1 mA.The ON/OFF switch is used only for the completestoppage of the whole system. This switch is notavailable in the XTM. The function can be addedwith the use of the remote command moduleRCM-10.11.2 DISPLAY AND CONTROL PANELThe Xtender has an ON/OFF button and lightindicators at the front of the unit, allowing clearidentification of the operating mode.(41) The ON/OFF button allows the start-up orcomplete stop of the system. In the systemscomprising several units, each unit is started orstopped individually. For a simultaneous start-up of allthe units use the dry contact control (see sect. 7.7 –p. 32) or the ON/OFF button of the RCC-02/-03remote control.Even when the equipment has stopped,dangerous voltages may be present at theXtender input.(42) This indicator lights up when the equipment has been stopped manually using the ON/OFFbutton (41) or due to a fault.The table below describes the type of fault according to the number of flashes on the indicator (42).XTSXTH et XTM |
manualsdatabase
Your AI-powered manual search engine