Xtender XTS 900-12 User Manual
                                                        | |
Contents
| 
Studer Innotec SAXtenderUser manual V4.6.0 41(44) This indicator is lit continuously when the charger is working and has not yet reached itsabsorption phase.It flashes twice during the absorption phase and once during the floating phase. It will flash 3 timeswhenever equalisation is activated.If the Smart Boost mode has been activated, this indicator stops blinking temporarily when sourcebackup is required by users (loads).(45) This indicator is lit continuously when an alternative voltage with correct values, either infrequency {1112-1505-1506} or in voltage {1199}, is present at the AC input of the device and thecurrent limit set by the user has not been reached.It flashes one time when the current limit at the input {1107} set by the user has been reached. In thiscase the charger current is reduced in order to guarantee priority supply to the users (see sect. 7.2.2.2- p. 27).If the Smart Boost mode (see sect. 7.2.2.4 – p. 28) is used and the inverter is part of the user supply –therefore the battery is discharged – the "charge" indicator (44) will be glowing.If the input current is exceeded nevertheless, and this exceed not permitted by parameter{1436}, theXtender goes back to inverter mode (transfer relay open) and the indicator (42) will keep flashing aslong as the user current exceeds the limit value of the input current {1107}.If grid feeding is allowed {1127} this indicator blinks 2 times while feeding.(46) This indicator is lit continuously when an alternative voltage of 230V is present at the equipmentoutput. It flashes when the device is in "load search" mode according to sect. 7.1.1 – p. 26.(47) Receipt button to stop the acoustic warning (XTM only). The duration of the acoustic alarm {1565}by factory default is 0 sec (deactivated).12 MAINTENANCE OF THE INSTALLATIONWith the exception of periodic checks of connections (tightening and general condition), theXtender does not require any special maintenance.13 PRODUCT RECYCLINGThe models of the Xtender series conform to the European directive2011/65/EU on hazardous substances and do not contain the followingelements: lead, cadmium, mercury, hexavalent chrome, PBB or PBDE.To dispose of this product, please use the service for the collection ofelectrical waste and observe all applicable obligations according to theplace of purchase.14 EC DECLARATION OF CONFORMITYThe inverter and accessories described in this manual comply with the following directive andstandards:Directive 2004/108/EC:Reference standards: EN 61000-6-1, EN 61000-6-3, EN 55014, EN 55022, EN 61000-3-2, EN 62040-2Low voltage directive 2006/95/EC:Reference standards: EN 50178/IEC 62103, EN 62040-1, EN 62109-1, EN 60950-1Directive RoHS: 2011/65/EUCH -1950 Sion, September 2015Studer Innotec SA - R. Studer |
manualsdatabase
Your AI-powered manual search engine