YASKAWA MECHATROLINK-II SI-T3 Technical Manual

Also see for SI-T3 MECHATROLINK-II A1000 Series: Installation manual Technical manual Installation manual Installation manual

3 Receiving8 YASKAWA SIEP C730600 86F MECHATROLINK-II Technical Manual3 ReceivingAfter receiving the option package:• Make sure that the option is not damaged and no parts are missing.Contact your sales outlet if the option or other parts appear damaged. Contact your sales outlet if there isdamage to the option or other parts.NOTICE Damage to Equipment. Do not use damaged parts to connect the drive and the option. Failure to complycould damage the drive and option.• Make sure that the model number on the option nameplate and the model number on the purchase order are thesame. Refer to Figure 4.1 for more information.• Contact the distributor where the option was purchased or contact Yaskawa or a Yaskawa representative aboutany problems with the option.◆ Contents and PackagingTable 3.1 Contents of PackageDescription: Option Ground Wire *1 Screws (M3)LED labelsInstallation Manual1000-SeriesGA500, GA700,GA800, CR700, andCH700-Quantity: 1 1 3 *2 1 1 1*1 GA700, GA800, CR700, and CH700 drives do not use the ground wire.*2 GA700, GA800, CR700, and CH700 drives use two screws only.◆ Installation Tools• A Phillips screwdriver or slotted screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in)) *1.• A pair of diagonal cutting pliers.• A small file or medium-grit sandpaper.*1 Phillips screw sizes are different for different drive capacities.