No. Parameter Name Default SettingE1-03 V/f Pattern Selection 0FHL2-01 Momentary Power Loss Operation Selection 1: EnabledL3-04 Stall Prevention Selection duringDeceleration 1: EnabledTable 4.12 Compressor: User Parameters (A2-01 to A2-16):No. Parameter Name No. Parameter Nameb1-01 Frequency Reference Selection 1 E1-03 V/f Pattern Selectionb1-02 Run Command Selection 1 E1-07 Middle Output Frequencyb1-04 Reverse Operation Selection E1-08 Middle Output Frequency VoltageC1-01 Acceleration Time 1 E2-01 Motor Rated CurrentC1-02 Deceleration Time 1 − −u Setting 6: Preset 6Note: 1. Read the instructions listed in Notes on Controlling the Brake when Using Application Preset 6 onpage 101 when using Application Preset 62. Perform Auto-Tuning after selecting Application Preset 6.3. If UL3 appears on the operator display after Auto-Tuning is complete, set L6-01 to “0” to repeat theAuto-Tuning process.Table 4.13 Preset 6: Parameters and SettingsNo. Parameter Name Default SettingA1-02 Control Method Selection 2: Open Loop Vector Controlb1-01 Frequency Reference Selection 1 0: Operatorb6-01 Dwell Reference at Start 3.0 Hzb6-02 Dwell Time at Start 0.3 sC1-01 Acceleration Time 1 3.0 sC1-02 Deceleration Time 1 3.0 sC6-01 Drive Duty Selection 0: Heavy DutyC6-02 Carrier Frequency Selection 2: 5 kHzd1-01 Frequency Reference 1 6.0 Hzd1-02 Frequency Reference 2 30.0 Hzd1-03 Frequency Reference 3 60.0 HzE1-03 V/f Pattern Selection 0FHH2-02 Terminals P1 Function Selection 37: During Frequency Output4.5 Application Selection100 YASKAWA ELECTRIC TOEP C710606 47A YASKAWA AC Drive – V1000 Quick Start Guide
