8 FT-1900E OPERATING MANUALCabin Engine Room FT-1900EBatteryRED: Positive (+)BLACK: Negative (–)13.8V15A FUSE15AMobile Power ConnectionsTo minimize voltage drop and avoid blowing the vehicle’s fuses, connect the supplied DCpower cable directly to the battery terminals. Do not attempt to defeat or bypass the DCcable’s fuse - it is there to protect you, your transceiver, and your vehicle’s electrical system.Warning!Never apply AC power to the power cable of the FT-1900E, nor DC voltage greaterthan 15.8 Volts. When replacing the fuse, only use a Vertex Standard’s 32 V/15 Afuse. Failure to observe these safety precautions will void the Limited Warranty onthis product. Before connecting the transceiver, check the voltage at the battery terminals while rev-ving the engine. If the voltage exceeds 15 Volts, adjust the vehicle’s voltage regulatorbefore proceeding with installation. Connect the RED power cable lead to the POSITIVE (+) battery terminal, and the BLACKpower cable lead to the NEGATIVE (–) terminal. If you need to extend the power cable,use #12 AWG or larger insulated, stranded copper wire. Solder the splice connectionscarefully, and wrap the connections thoroughly with insulating electrical tape. Before connecting the cable to the transceiver, verify the voltage and polarity of thevoltage at the transceiver end of the DC cable using a DC voltmeter. Now connect thetransceiver to the DC cable.INSTALLATIONMobile SpeakersThe optional MLS-100 External Speaker includes its own swivel-type mounting bracket,and is available from your Yaesu dealer.Other external speakers may be used with the FT-1900E, if they present the specified 4-Ohmimpedance and are capable of handling the 3 Watts of audio output supplied by the FT-1900E.MOBILE I NSTALLATIONWARNING!· Never remove the FUSE holders from the DC cable.· Use only a Vertex Standard’s 32 V/15 A fuse.

Introduction

Specifications

Installation

Mobile Installation

Mobile Power Connections

AC Power Supplies

microphone jack

Basic Operation

Tuning Dial

Transmission

RF Squelch

Standard Repeater Shift

Repeater Operation

CTCSS Operation

Tone Search Scanning

EPCS Operation

paging answer back

Manual DTMF Tone Generation

Memory Recall

Memory Tuning

Memory Bank Operation

Removing Memories from a Memory Bank

HOME Channel Memory

Frequency Navigation

Scanning

Preferential Memory Scan

Memory Bank Link Scan

Memory Operation

Priority Revert Mode

Weather Alert Scan

setting the smart search mode

Smart Search Operation

Internet Connection Feature

ARTS

ARTS™ Polling Time Options

CW Identifier Setup

CW Training Feature

Packet Operation

Password

Time-Out Timer

Reset Procedure

Cloning

Busy Channel Lock-Out

Memory Storage

declaration of conformity

Yaesu FT-1900E Operating Manual

FT-1900E