Yaesu FT-950 Operating Manual

Also see for FT-950: Brochure & specs Reference Manual Update Update

Page 112 FT-950 OPERATING M ANUAL041 A1A CW AUTOFunction: Enables/disables CW keying while operatingon SSB.Available Values: OFF/50/OnDefault Setting: OFFOFF: Disables CW keying while operating on SSB.50: Enables CW keying only while operating SSB on 50MHz (but not HF).On: Enables CW keying while operating on SSB (all TXbands).NOTE:This feature allows you to move someone from SSB toCW without having to change modes on the front panel.042 A1A BFOFunction: Sets the CW carrier oscillator injection side forthe CW mode.Available Values: USb/LSb/AutoDefault Setting: USbUSb: Injects the CW carrier oscillator on the USB side.LSb: Injects the CW carrier oscillator on the LSB side.Auto: Injects the CW carrier oscillator on the LSB sidewhile operating on the 7 MHz band and below, andthe USB side while operating on the 10 MHz bandand up.043 A1A BK-INFunction: Sets the CW “break-in” mode.Available Values: SEni/FuLLDefault Setting: SEniSEni (SEMI): The transceiver will operate in the semibreak-in mode. The delay (receiver recovery) time is setvia the Menu item “044 A1A DELAY044 A1A DELAY044 A1A DELAY044 A1A DELAY044 A1A DELAY”.FuLL: The transceiver will operate in the full break-in(QSK) mode.044 A1A DELAYFunction: Adjusts the Keying Delay (receiver recovery)time on the CW mode.Available Values: 30 ~ 3000 msec (10 msec/step)Default Setting: 200 msec045 A1A PITCHFunction: Adjusts your preferred CW tone pitch.Available Values: 300 ~ 1050 HzDefault Setting: 700 Hz046 A1A WEIGHTFunction: Sets the Dot:Dash ratio for the built-in elec-tronic keyer.Available Values: (1:) 2.5 ~ 4.5Default Setting: 3.0047 A1A FRQDISPFunction: Selects the frequency Display Format for theCW mode.Available Values: dir/OFStDefault Setting: OFStdir (Direct Frequency): Displays the receiver carrier fre-quency, without any offset added.When changing modes betweenSSB and CW, the frequency dis-play remains constant.OFSt (Pitch Offset): This frequency display reflects theadded BFO offset.048 A1A PC KYNGFunction: Enables/disables CW keying from the “DATAIN” terminal (pin 1) on the rear panel’s RTTY/PKT jackwhile operating on the CW mode.Available Values: EnA (Enable)/diS (Disable)Default Setting: diS (Disable)049 A1A QSKTIMEFunction: Selects the time delay between when the PTTis keyed and the carrier is transmitted during QSK opera-tion when using the internal keyer.Available Values: 15/20/25/30 msecDefault Setting: 15 msecMENU M ODEMODE-CW GROUP