Yaesu FT-991 Operating Manual

Also see for FT-991: Manual Manual Operating manual Reference book Instruction manual

Page 68FT-991 O PERA T ING M ANUALchecking the cw MeMory contentS1. Be sure that Break-in is still turned “Off” by [BK-IN]on the LCD.2. Touch [MONI] on the LCD to enable the CW moni-tor.3. Press the FH-2 [1] ~ [5] key, whichever memoryyou just recorded in. You will hear the results in thesidetone monitor, but no RF energy will be transmit-ted.on -the -A ir cw MeSSAge plAybAck1. Touch [BK-IN] on the LCD to enable transmission.Either Full- or Semi-break-in will be engaged, de-pending on the setting of Menu item “057 CW BK-IN”.2. Press the FH-2 [1] ~ [5] key, depending on whichCW Memory Register message you wish to transmit.The programmed message will be transmitted on theair.note:If you subsequently decide to use the “Text Memory”technique for memory storage, please note that a mes-sage stored using keyer paddle input will not be trans-ferred over when you select “Text Memory technique”on a particular memory register (the Menu Mode Settingis set to “TEXT”).conteSt MeMory keyer (uSing the optionAl Fh-2 reMote control keypAd)M eSSAge MeMory progrAMMing (uSing your pAddle)1. Set the operating mode to CW.2. Set [BK-IN] on the LCD to “Off”.3. Turn the internal Electronic Keyer “On”.4. Press the [MEM] key on the FH-2. A blinking “REC”icon will appear in the display.5. Press any of the FH-2 keys numbered [1] through [5]to begin the memory storage process, and the “REC”icon will glow steadily.6. Send the desired message using your keyer paddle.A dvice :If you do not start keying within ten seconds, thememory storage process will be cancelled.7. Press the [MEM] key on the FH-2 once more at theend of your message. Up to 50 characters may bestored in each of the five memories.Cw C onvenienCe feaTures