Yaesu FT-991 Operating Manual

Also see for FT-991: Manual Manual Operating manual Reference book Instruction manual

Page 80FT-991 O PERA T ING M ANUALM eMorY operaTionM eMory groupSMemory channels may be arranged into as many as six convenient groups, for easy identification and selection. For ex-ample, you might want to designate memory groups for AM BC stations, short-wave broadcast stations, contest frequen-cies, repeater frequencies and PMS limits, or any other groupings you like.Each memory group is capable of holding up to 20 memory channels (except Memory Group 01: it is 19 memory chan-nels, and the Group size is fixed). When a memory channel is grouped, the channel numbers change to correspond to thechart below:Memory Group Assignment1. Press the MENU(SETUP) button to enter the Menumode.2. Rotate the MULTI knob to select Menu item “033MEM GROUP”.3. Touch [SELECT] on the LCD, then rotate theMULTI knob to set this Menu item to “ENABLE” (thedefault setting is “DISABLE”).4. Touch [ENTER] on the LCD to save the new set-ting.5. Press the MENU(SETUP) button or [BACK] on theLCD to exit. Operation will now be restricted to thesix Memory Groups.To cancel Memory Group operation, repeat steps (1)through (4) above, choosing “DISABLE” in step (3).A dvice :To avoid confusion, note that the PMS memory groupand the PMS memories “P-1L” through “P-9U” will beso designated.group MeMory “oFF”01 ~ 1920 ~ 3940 ~ 5960 ~ 7980 ~ 99P-1L/1U ~ P-9L/9U5M-01 ~ 5M-10M eMory chAnnel nuMbergroup MeMory “on”1-01 ~ 1-192-01 ~ 2-203-01 ~ 3-204-01 ~ 4-205-01 ~ 5-20P-1L/1U ~ P-9L/9UUS-1 ~ US-5Choosing the Desired Memory GroupYou may recall memories just within a particular Memory Group, if desired.1. Press the V/M button, if necessary, to enter the“Memory” mode.2. Press the F(M-LIST) button, then touch [GRP] onthe LCD. The “GRP” icon will appear on the dis-play.3. Rotate the MULTI knob to select the desired Memo-ry Group.4. Press the F(M-LIST) button, then touch [MCH] onthe LCD. The “MCH” icon will appear on the dis-play.5. Rotate the MULTI knob to select the desired Memo-ry Channel within the Selected Memory Group.A dvice :If no channels have been assigned to a particular Memo-ry Group, you will not have access to that Group.MENU(SETUP) ButtonMULTI KnobF(M-LIST) ButtonV/M ButtonMULTI Knob