Yaesu FT3DR Instruction Manual

Also see for FT3DE: Operating manual Manual Instruction manual Instruction manual Operating manual

Contents

8The WIRES-X DG-ID setting screen will be displayed.2 Rotate the DIAL knob to set the WIRES-X DG-ID to the same ID number as the nodestation.AUTO: Only open nodes, set to the DG-ID number “00” may be connected.01 to 99: Only nodes matching the set DG-ID number may be connected.3 Press the PTT.Returns the screen to the frequency display screen.4 Rotate the DIAL to set the A-band to the frequency of the desired local node.CautionWIRES-X can only be used on the A-band.If using the B-band (shown on the bottom part of the screen) as the operation band, pressing the [X]key automatically switches the operation band to the A-band (shown on the top part of the screen).5 Press the [X ] key.[X ] flashes on the left side of the frequency display.Tip • While [X ] is flashing, briefly press the [X ] key to re-establish connection to the local node.• When any local node cannot be found, [X ] will disappear in 30 seconds.When a local node is found, [X ] is lit solid, and the node name and city name appearon the bottom part of the screen.Tip Depending on the connection status, the screen will show one of four display patterns.(1) Connected to the local node, but unable to connectto Internet nodes or rooms (never before establishedconnection to Internet nodes or rooms)SEARCH & DIRECTJQ1YBG-ND1 Shinagawa-(2) Connected to the local node, but unable to connectto Internet nodes or rooms (previously succeeded inestablishing connection to Internet nodes or rooms)SEARCH & DIRECTJQ1YBG-ND1 Shinagawa-JA1YOE-ROOM12345