6D81G11 5-44123456789NOTE:Install the bearings in their original positions.3. Put a piece of Plastigauge (PG-1) ontothe crankpin, parallel to the crankshaft.NOTE:Be sure not to put the Plastigauge (PG-1)over the oil hole in the crankpin of the crank-shaft.4. Install the connecting rod to the crankpin3.NOTE:Make sure that the large, flat side a on theconnecting rod faces towards the flywheelmagnet side of the crankshaft.5. Tighten the connecting rod bolts to thespecified torques in two stages.NOTE:• Reuse the removed connecting rod bolts.• Do not turn the connecting rod until thecrankpin oil clearance measurement hasbeen completed.S60C596012T R..Connecting rod bolt:1st: 18 N·m (1.8 kgf·m, 13.3 ft·lb)2nd: 80°S60C5A10aCylinder block
