6D81G11 7-38123456789Disassembling the trim cylinder1. Hold the power trim and tilt unit 1 in avise using aluminum plates a on bothsides.2. Loosen the trim cylinder end screw 2,and then remove it.WARNINGMake sure that the ram is fully extendedbefore removing the end screw.3. Drain the power trim and tilt fluid.Disassembling the tilt cylinder1. Hold the tilt cylinder 1 in a vise usingaluminum plates a on both sides.NOTE:Place the tilt cylinder in the vise horizontally.2. Loosen the tilt cylinder end screw 2, andthen remove it.CAUTION:Do not damage the check valve b whenloosening the end screw.3. Hold the tilt ram end in a vise using alu-minum plates on both sides.Trim cylinder wrench:YB-06175-2BTrim cylinder wrench:YB-06175-2BTilt cylinder and trim cylinder
