6D81G11 6-121234567893. Remove the oil seals and needle bear-ing.Checking the propeller shaft housing1. Clean the propeller shaft housing using asoft brush and cleaning solvent, and thencheck it for cracks. Replace if necessary.2. Check the teeth and dogs of the reversegear for cracks or wear. Replace thegear if necessary.3. Check the bearings for pitting or rum-bling. Replace if necessary.Checking the propeller shaft1. Check the propeller shaft for bends orwear. Replace if necessary.2. Measure the propeller shaft runout.3. Check the dog clutch and slider forcracks or wear. Replace if necessary.Assembling the propeller shaftassembly1. Install the dog clutch as shown.NOTE:Install the dog clutch 1 with the “F” mark afacing toward the slider.Slide hammer 2: YB-06096Bearing puller legs 3: YB-06523Bearing housing needle bearingremover 4:YB-06153Driver handle (large) 5: YB-06071S6D56510Runout limit: 0.02 mm (0.0008 in)Propeller shaft housing
