POWR Power unit5-11 6D81G114. Install the driven sprockets 0, timing belt9, and spring 8, and then tighten thetensioner bolt.5. Check the intake valve clearance for cyl-inders #1 and #2, and the exhaust valveclearance for cylinders #1 and #3. Adjustif out of specification.NOTE:• Check the valve clearance when the engineis cold.• Note the measurement.6. Turn the flywheel magnet 360° clock-wise.7. Check the intake valve clearance for cyl-inders #3 and #4, and the exhaust valveclearance for cylinders #2 and #4. Adjustif out of specification.8. Turn the flywheel magnet clockwise andalign the “TDC” mark on the flywheelmagnet with the pointer, and check thatthe “ ” marks on the driven sprocketsare aligned.9. Loosen the tensioner bolt 7, and thenremove the spring 8, timing belt 9,driven sprockets 0, camshaft caps A,and camshafts B.NOTE:Do not mix the valve train parts. Keep themorganized in their proper groups.10. Remove the valve lifters from the cylinderhead.S6D85160809S6D85170IN EX#1#2#3#4f eValve clearance (cold):Intake e:0.20 ± 0.03 mm (0.008 ± 0.001 in)Exhaust f:0.34 ± 0.03 mm (0.013 ± 0.001 in)S6D85180BA00798
