Yamaha PDM-4220 User Manual

Also see for PDM-4220: User manual Service manual

42OTHER FUNCTIONS (continued)Signal Check (RGB mode)Changes in the signal status are displayed on the screen as they arise.StatusWhen Mode Display is set to ON,the input signal is switched orwhen the RECALL button ispressed.When the sync signal is no longerdetected.When the input signal does notmatch the monitor specificationsor is in an unstable state.DisplayA guide is displayed for the inputterminal and the horizontal andvertical sync frequency.• A guide displays No Sync.Signal, and Power Save (forapprox. 5 sec.)• When the condition continueswhere the sync signal cannot bedetected, indicator lamp ofpower source changes inorange and the mode switchesto power save mode.A duide displays Invalid ScanFreq.Action––––––––––Recheck the personal computerpower switch status and theconnection status.Recheck the input signalspecifications.RGB2RGBH : 48.4kHzV : 60.1 Hz-- -- Min.-- -- : -- --OFF! No Sync. Signal! Invalid Scan Freq.RGB48 ~ 50DVD Player Selection (continued)Set up hintExample) YAMAHA 1 DVD ( )To operate the YAMAHA DVD player, set the FUNCTION SELECTswitch to the DVD position.1. Set up the maker.Press and hold the button, and followed by pressing formore than 1 second.2. Set up the type.Release the button whilst keeping button depressed.Then, press the ➆ for more than 1 second.3. Confirm the setting.After setting the maker and type, press the STANDBY/ON buttonon the remote control. If the DVD does not switch on, repeat step1 and 2 using other types ( in this case, ➇)as listed in the charton .NOTE• Not all models of the listed makers can be operated using thisremote control.41STANDBY/ON RECALLTV DVD/I i+AV 1 AV 2 AV 3 AV 4AV 5MENUVOL PROGA. MODE P. MODERETURNAV 6 RGB 1 RGB 22 34 5 67 809?iI/II2-4-121OK+ P+PRECALL buttonPROGRAM SELECTbuttonsFUNCTION SELECTswitchTEXT/TV + TEXTbutton2-4-122-4-122-4-12