17 EnPlaybackBASICOPERATION English■ Adjusting the BASS and TREBLEcontrolsThe BASS +/– and TREBLE +/– adjust high and lowfrequency response.When you adjust to “0”, produces a flat response.BASSIncreases or decreases the low frequency response.Control range: –10 to +10 (20 Hz)TREBLEIncreases or decreases the high frequency response.Control range: –10 to +10 (20 kHz)yBASS and TREBLE can be adjusted in the “Setup” menu (p.33).■ Adjusting the speaker balanceThe sound output balance of the left and right speakers tocompensate for sound imbalance caused by speakerlocations or listening room conditions.To adjust the speaker balance, perform the followingsteps.1 Press SETUP on the remote control.The “Setup” menu shown on the front display.2 Press B/C to select “Balance” and press ENTER.3 Press D/E to adjust speaker balance.Control range: L+10 to R+104 To exit from the “Setup” menu, press SETUPagain.Use this feature to automatically set this unit to standbymode after a certain amount of time. The sleep timer isuseful when you are going to sleep while this unit isplaying or recording a source.The sleep timer can only be set with the remote control.1 Press SLEEP repeatedly to set the amount oftime before this unit is set to standby mode.Each time you press SLEEP, the front displaychanges as shown below.The SLEEP indicator blinks while setting the amountof time for the sleep timer.If the sleep timer is set, the SLEEP indicator on thefront display lights up.y• To disable the sleep timer, select “Sleep Off”.• The sleep timer setting can also be canceled by pressingA (power) to set this unit to standby mode.STANDBY/ONVOLUMERETURNPUSH - ENTERTUNINGPRESETFM/AMMEMORYBASS TREBLE INPUTFM MODEDISPLAYSELECTPHONES SPEAKERSA BBASSTREBLESETUPPOP-UP MENU HOME NOW PLAYINGMUTEVOLUMERETURNENTERSETUPENTERCursor keysB / C / D / ESP A¡Network¡SetupSetupSP A¡L------------R›BalanceUsing the sleep timerNoteMODELINE 1COAXIAL OPTICAL NETLINE 2 LINE 3TUNER CDDIMMER SLEEPBASPEAKERSASLEEP(power)SP ASleep¡120min.SLEEPP An.SLEEPSLEEP