Yamaha RX-V340 Owner's Manual

Also see for RX-V340: Service manual Owner's manual

Contents

15EnglishPREPARATION10 mm (3/8”)Red: positive (+)Black: negative (–)Banana plugCONNECTIONS1 2 ConnectionsBe sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) in accordance with the markers onthis unit, the speakers, and the speaker cables. If the connections are faulty, no sound will be heard from the speakers,and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.CAUTION• Use speakers with the specified impedance shown on the rear panel of this unit.• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.A speaker cord is actually a pair of insulated cablesrunning side by side. One cable is colored or shapeddifferently, perhaps with a stripe, groove or ridge.1 Remove approximately 10 mm (3/8”) ofinsulation from each of the speaker cables.2 Twist the exposed wires of the cabletogether to prevent short circuits.1 Unscrew the knob.2 Insert one bare wire into the hole in the sideof each terminal.3 Tighten the knob to secure the wire.y(With the exception of U.K., Europe, Korea, and Singaporemodels)• You can also use banana plug connectors. First, tighten theknob and then insert the banana plug connector into the end ofthe corresponding terminal.1 Press and open the tab.2 Insert one bare wire into the hole of eachterminal.3 Release the tab to secure the wire.(With the exception of U.K., Europe, Korea, andSingapore models)Connecting to the MAIN A SPEAKERS terminals3 12Red: positive (+)Black: negative (–)Connecting to the MAIN B, CENTER and REAR SPEAKERS terminals123