Yamaha SRT-1500 Owner's Manual

Also see for YSP-1600: Quick reference guide Quick reference guide Quick reference guide Quick reference guide Service manual

Contents

PREPARATIONS ➤ f Initial settings En 201 Turn on the unit, TV, and playback devices.2 Activate the HDMI control function on the unit, TV,and playback devices such as BD/DVD players thatsupport this function.For this unit, be sure that “HDMI Control” is set to “On”(default; p. 50).For playback devices, refer to the instructions supplied witheach device.3 Turn off the main power of the TV and then turn offthe unit and playback devices.4 Turn on the unit and playback devices and then turnon the TV.5 Switch the TV input to display the video from theunit.6 Press the HDMI key to select HDMI input, and checkthat video from the playback device is properlydisplayed.7 Check that the unit is properly coordinated with theTV by turning off the TV or adjusting the TV volumewith the TV remote control.When the connected devices and jacks are changed, configure thesettings again with the following procedure.1 Disable the HDMI control function of the TV and BD/DVD player, turn off all connected devices, andchange the connections.2 Follow steps 1 to 7 of “Setting the HDMI controlfunction”.Setting the HDMI control functionHDMIGlows (green)If devices are not coordinatedBe sure that all devices are correctly connected to this unit, andthat settings are properly configured as described below.– “HDMI Control” (p. 50) is set to “On” in the setup menu.– The HDMI control function is enabled on the TV.The example of TV settings• From the setup menu on your TV, select “Link setting” “HDMI control setting”, then set a setting such as “HDMIcontrol function” to “ON”.• Set audio output to any option other than TV.If devices fail to coordinate even after the settings describedabove have been applied correctly:– Turn off this unit and the TV, and then turn them back on again.– Disconnect the power cable of the unit and external devicesconnected to the unit via HDMI cable. Plug them in again afterabout 30 seconds.– If devices fail to coordinate after ANALOG is input, repeatsteps 5 and 6 under “Setting the HDMI control function”.Changing the connection method andconnected devices1 2 3 4 5 6HDMI