PERIODIC MAINTENANCE AND ADJUSTMENT7-2874. Pull the wheel axle out, and thenremove the wheel. NOTICE: Donot apply the brake after thewheel has been removed to-gether with the brake disc, oth-erwise the brake pads will beforced shut. [ECA11071]EAU41422To install the front wheel1. Lift the wheel up between the forklegs.TIPMake sure that there is enough spacebetween the brake pads before install-ing the wheel.2. Insert the wheel axle from the rightside.3. Lower the front wheel so that it ison the ground, install the remov-able sidestand, and then rest themotorcycle on it.4. Install the washer and axle nut,and then tighten the axle nut to thespecified torque.EAU25080Rear wheelEAU41313To remove the rear wheelWARNINGEWA10821To avoid injury, securely support thevehicle so there is no danger of itfalling over.1. Loosen the axle nut.2. Lift the rear wheel off the groundaccording to the procedure onpage 7-27.3. Fully loosen the locknut, and thenloosen the drive chain slack ad-justing bolt on each side of theswingarm.4. Remove the axle nut and washer.1. Wheel axleTightening torque:Axle nut:70 Nm (7.0 m·kgf, 51 ft·lbf)U5PA89E0.book Page 28 Tuesday, June 15, 2010 10:34 AM