2 - 37SPECCABLE ROUTINGÈ Route the horn lead under therib of bracket horn positioningthe stepped part of protectoroutside the rib.É Make the horn lead face theoutside.Ê Route the handlebar switch leadalong the groove of the guide-air.Ë Handlebar switch (right) leadcoupler.Ì Fasten the wire harness andcoolant temperature sensorlead with the clamp inserted tothe frame. Point the clamp tipdownward.Í To starter motorÎ To pick-up coilÏ To fuel pumpÐ Insert the holding clamp of thewire harness to the frame.Route the starter motor leadand crankshaft position sensorlead under the throttle body.Ñ Wiring section #Ò Connect the leads behind theclamp. (without crankshaftposition sensor lead)Fasten the wire harness, speedsensor, neutral switch, rearbrake switch, pick-up coil andstarter leads with the clampinserted to the frame.Ó EXUP servo motorÔ To rectifier regulatorÕ Fasten the wire harness, (–)lead, AC magneto lead andrectifier regulator lead junctionwith the clamp inserted to thebox battery.Ö Fasten the wire harness, AIsystem lead, AC magneto lead,oil level gauge lead, sidestandswitch lead and injector sublead with the clamp inserted tothe frame.× Pay attention to the direction ofinstallation.Ø Connect the leads between theclamp and the junction.Ù Route the (–) and AC magnetoleads under the wire harness.
