Yealink T41P Setup And User Manual

Also see for T41P Skype: Administrator's guide Administrator's guide Registering and using Manual Manual

Contents

Yealink T41P Setup And User Manual Manual pdf 7 page image

________________________________________________________________Copyright © 2005-2015 MyPhones Ltd 7/23o If you are using an external power source plug the power supply cable intothe power port on the phone base.NOTE. The Yealink T42G does not ship with a power supply. If you are notusing Power over Ethernet (PoE), you must order a suitable power supplyseparately.o If you are using Power over Ethernet (PoE) to power the phone, the phonewill receive power when you connect an Ethernet cable from the phone’sInternet port to a switch in your network that provides PoE.o If you are using a headset, plug the 2.5mm jack into the port on the lefthand side of the phone.2.3. RouterYour router should be set up to perform NAT (Network Address Translation) andact as a DHCP server (or have a standalone DHCP server somewhere on yournetwork). These features are normally enabled by default on most routers.An IP address will be allocated to the phone automatically when you plug theEthernet cable from your phone into your router.It is our strong recommendation to minimise the number of firewall rules requiredon the router. This will reduce the CPU load on the router and also future proof thesite from future additions to the service.This can be simply implemented by two rules which allow all (UDP and TCP) trafficto and from 154.51.129.0 and 217.135.162.0 netmask 255.255.255.0 - this is a/24 network.You should also disable any Application-level Gateway (ALG) on your router.The system can support both static and dynamic IP addresses.2.4. Making the ConnectionPlug in the network and power connections. The phone will then perform a boot-upsequence. During this sequence the Power LED (on the top right of your phone)will glow red and the phone screen will display ‘Welcome’ followed by ‘Initializing…Please wait’. Once the phone is initialized the Power LED will go out.After your phone is successfully connected to the network and receives a basicconfiguration, the phone screen will then display the standard menu for the phone.The time and date in the centre with the last 5 digits of your primary accountnumber and at the bottom action commands are displayed over their associatedsoft keys. The buttons on the left hand side of the screen display the the last 5digits of their associated line numbers. Only 3 line accounts are permitted.You should now hear a dial tone when you pick up the handset, press a line buttonor press the loudspeaker button. Try making a call.