Configuring Network67A dialog box pops up to prompt that the settings will take effect after a reboot.6. Click OK to reboot the phone.To configure VLAN via the remote control:1. Select Menu->Advanced (default password: 0000) ->Advanced Network.2. In the VLAN block, check the Active checkbox.3. Enter the VLAN ID in the VID(1-4094) field.4. Enter the priority value (0-7) in the Priority field.5. Press the Save soft key to accept the change.The display device prompts “Reboot now?”.6. Select OK to reboot the system immediately.DHCP VLANThe system supports VLAN discovery via DHCP. When the VLAN Discovery method is set toDHCP, the system will examine the DHCP option for a valid VLAN ID. The predefined option 132is used to supply the VLAN ID by default. You can customize the DHCP option used to requestthe VLAN ID. For more information on VLAN, refer toVLAN Feature on Yealink IP Phones.Parameters of VLAN feature on the system are described below.Parameter Description Configuration MethodDHCPVLAN->ActiveEnables or disables the DHCP VLANdiscovery feature on the system.Default: EnabledNote: If you change this parameter,the system will reboot to make thechange take effect.Web User InterfaceOptionConfigures the DHCP option fromwhich the system obtains the VLANsettings.You can configure at most five DHCPoptions and separate them bycommas.Valid Values: 128-254Default: 132Note: If you change this parameter,the system will reboot to make thechange take effect.Web User Interface
