Yealink W52P Configuration Manual

Also see for Telkom W52P: Auto provisioning guide Getting started Recovery guide Deployment guide Quick installation guide

Contents

Yealink W52P Configuration Manual Manual pdf 39 page image

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W52P IP DECT PHONE 20-BD5392-00©2013 YEALINK PAGE 39 OF 54Parameter Value Description/NotesLine/Port Example:8881001099@as.iop1.broadworks.netSupply the desired SIP registeraddress-of-record.Example user Addresses settings:Figure 10 Addresses Settings5.2.5 Configure Edge DeviceIn many deployments, an edge device is deployed on the enterprise edge. Configure theedge device SIP server setting with the service provider’s session border controller IPaddress or FQDN. If there is no edge device and the phones communicate directly withthe service provider’s SBC, skip this section.To integrate the edge device with Device Management, the SBC address tag(%SBC_ADDRESS%) defined in section 5.2.1.1 Create System Default Tags must beoverridden at the group level with the LAN address of the edge device. At the Group →Utilities → Device Configuration page, select the Yealink device profile (example:Yealink_W52P). Perform the following steps.1) Click on the Custom Tags tab.2) Click the Add button.3) Add the SBC tag.4) Enter “SBC_ADDRESS” as the tag.5) Enter the IP address as the value (edge device LAN IP address).6) Click OK to save the tag data.This Tag/Value will be applied to all Yealink W52P phones in the group using the modifiedDevice Profile Type.