Variant 2: Peak loadfan with different amount ofairZuschaltpunkttrigger point(variabel)10010001000Ventilatorfan1nM[%]R[%]1Spitzenlastpeak load23417.09.2008v_dia_spila_varia2.vsd1 Fan2 Max. load3 Connection point (variable)4 Max. load OnnM Motor speedR PbandVariant 3: Peak loadfan with equal amount of airZuschaltpunkttrigger point(variabel)10010001000Ventilatorfan1nM[%]R[%]1SpitzenlastPeak load23417.09.2008v_dia_spila_varia3.vsd1 Fan2 Max. load3 Connection point (variable)4 Max. load OnnM Motor speedR Pband7.2.5 Humidity controlRH modeRH modeOn activating the humidity control (Humidity mode = “ON”) input “E2” is programmedautomatically for connecting a humidity sensor (0 - 100 % r.h. 0 - 10V).e.g. Type MFTG-100V (Part.-No. 384033)The input must be adapted with the two internal plugs for “E2”.The humidity control acts at the same output as the control circuit for the ventilation.If the stall temperature is reduced below the temperature setpoint of the ventilation bythe inuence of the humidity control, the humidity inuence is reduced within an adjust-able range (“Humidity cooling” in the Installation menu) linearly to “0”.RH coolingRH coolingSetting range: -20.0...0.0 KFactory setting: -5.0 KPosition of the internal plugs for input “E2”.V°CE2 E218.09.2008v_e2_0_10v_cte_pte.VSD°C at the factory = input for temperature sensor TF..(KTY81-210)V Input for 0 - 10 V signal (no PINs bridged)Connection humidity / temperature sensor typeMFTG-100V Art. No. 384033E2 GND E1 GND1 2 3MFTG-100V4 5V+ GND RH24V18.09.2008v_anschl_mftg_an_cte_pte.VSD0...10 V =0...100 % r. h.TF..(KTY81-210)Including temperature sensor (replaces a TFR)Operating Instructions UNIcon / Acontrol The Installation menuL-BAL-E051-GB 1035 Index 003 Part.-No. 00163311-GB23/83
