9.6.6 Curve for Heating2Heating2 curveHeating2 curve Factory setting curve for“Heating2” not active = OFF.This curve can be activated= ON if necessaryFunction only when using the temperature sensor on “E2”, “E3” or via busfrom the master device “Installation” - “Heating 2” - “H2 input” = |1|, |2| or|3|. The settings are absolute values in °CHeating2 startHeating2 startSetting range:-10.0...+60 °CFactory setting: 24.0 °CIncrease program Heating2Day[°C]31.10.2008v_sollw_kurve.VSDS0Start Knickpunkt1Break-point1Knickpunkt2Break-point2EndpunktFinal day12E[°C] Setpoint Heating2 in °CSHeating2 start1 Heating2knick12 Heating2knick2E Heating2 nalHeating2knick1Heating2knick1Setting range:-10.0...+60 °CFactory setting: 23.0 °CHeating2knick2Heating2knick2Setting range:-10.0...+60 °CFactory setting: 22.0 °CHeating2 nalHeating2 nalSetting range:-10.0...+60 °CFactory setting: 21.0 °COperating Instructions UNIcon / Acontrol Settings for operationL-BAL-E051-GB 1035 Index 003 Part.-No. 00163311-GB64/83
