9.6.4 Curve for Maximum VentilationMaximum curveMaximum curve Factory setting max. curve active = ON, if curve program is switchedon.This curve can be deactivated = OFF if necessaryMax. startMax. startSetting range: 50...100 %Factory setting: 75 %Increase program MaximumDay[%]31.10.2008v_max_kurve.VSDS0StartKnickpunkt1Break-point1Knickpunkt2Break-point2EndpunktFinal day12E[%] Maximum Ventilation in %SMax. start1 Max. knick12 Max. knick2E Max. nalMax. knick1Max. knick1Setting range: 50...100 %Factory setting: 80 %Max. knick2Max. knick2Setting range: 50...100 %Factory setting: 90 %Max. nalMax. nalSetting range: 50...100 %Factory setting: 100 %9.6.5 Curve for Heating1Heating1 curveHeating1 curve Factory setting heating1 curve active = ON, if curve program is switchedon.This curve can be deactivated = OFF if necessaryFunction only when using the temperature sensor in the stall “Installation” -“Heating 1” = H1 input = |0|.The set offset values refer to the setpoint of the ventilation (+/-)Heating1 startHeating1 startSetting range:-10.0...+10.0 KFactory setting: 0.0 KIncrease program Heating1Day[K]31.10.2008v_heizung1_kurve.VSDS0StartKnickpunkt1Break-point1 Knickpunkt2Break-point2 EndpunktFinal day12E[K] Heating offset in KSHeating1 start1 Heating1 knick12 Heating1 knick2E Heating1 nalHeating1 knick1Heating1 knick1Setting range:-10.0...+10.0 KFactory setting: -1.0 KHeating1 knick2Heating1 knick2Setting range:-10.0...+10.0 KFactory setting: -1.5 KHeating1 nalHeating1 nalSetting range:-10.0...+10.0 KFactory setting: -2.0 KOperating Instructions UNIcon / Acontrol Settings for operationL-BAL-E051-GB 1035 Index 003 Part.-No. 00163311-GB63/83
