USING THE ZOLL VENTILATOR4-22 www.zoll.com 906-0731-01-05 Rev. CTurning Off Alarms at Extreme Range LimitsIf the operator sets the following alarm limits to their extreme range, the ventilator turns off theindicated alarms after Pop Up message confirmation:1. High Breath Rate (Alarm #2074).2. PIP Low (Alarms #2071, 2171) -- the device automatically turns off these alarm limitsin NPPV mode.3. VT High (Alarms #2072, 2172) -- the device automatically turns off these alarm limitsin NPPV mode.4. VT Low (Alarms #2073, 2173) -- the device automatically turns off these alarm limitsin NPPV mode.5. Low SpO2 (Alarm #2410)6. High Heart Rate (Alarm #2410)7. Low Heart Rate (Alarm #2411)If an alarm has been turned off and is then modified, but is not accepted, then the alarmparameter is set to the values indicated in the following table. This is done to ensure patientsafety in the event of an inadvertent value change. You can change these values following theparameter change procedures described above.3300 SpO2 Shutdown (MS 11 Failure-Monitor Not In Use)3301 SpO2 Shutdown (Communication Failure EMV-Pulse Ox-Monitor Not InUse)3310 No SpO2 Sensor Connected (No Sensor Detected)3311 Defective Sensor3312 SpO2 Pulse Search3313 SpO2 Signal Interference3315 Too Much Ambient Light3316 Invalid SpO2 Sensor (Unrecognized Sensor)3317 Low SpO2 Perfusion (Low Perfusion)3318 Low SpO2 Perfusion (Poor SpO2 SignalService Code Alarm NameHighBreathRate PIP Low V T High VT Low Low SpO2 HighHeart Rate Low HeartRate99 BPM 3 cm H2O 2000 ml 0 ml 86% 240 BPM 30 BPM
