Zanussi ZKG5530 User Manual

Contents

28Moving your appliance• You may damage some soft or badly fittedfloor coverings when you move theappliance. The floor covering under theappliance should be securely fixed so it doesnot ruck up when you move the applianceacross it. Alternatively you could remove thefloor covering. This appliance is heavy andcare must be taken when moving it. Do nottry to move the appliance by pulling the doorhandles.• To move the appliance, open the grill door.Raise the appliance off its front feet by liftingit from inside the oven. Pull the applianceforward. When you replace the appliancepush it back to the stop and make sure thereis the same gap at each rear corner.For your safety• Do not try to disconnect the appliance fromthe gas supply if the supply pipe does nothave a bayonet connection, as described inthe installation instructions. If this is the casecontact the person who installed theappliance.Location of appliance• This appliance must not be installed in abed-sitting room of volume less than 20m 3 orin a bathroom, shower room or garage. It isessential that the appliance is positioned asshown.• Shelves, wall cabinets and cooker hoodsmust be fitted a minimum of 650mm directlyabove the top of the hob (or greater forcooker hoods if recommended bymanufacturers instructions) and 400mmabove the hob when fitted in line with theoutside of the appliance. If the units areintended to be fitted adjacent to theappliance butless than400mmabove thehob, then aminimumspace of50mm mustbemaintainedbetween thesides of theunit and theappliance.