Zanussi ZOP27901 User Manual

590° 621 7Open the door fully and hold the two door hinges.1Lift and turn the levers on the two hinges.2Close the oven door halfway to the first opening position. Then pull forward and remove the door fromits seat.3Put the door on a soft cloth on a stable surface.4Release the locking system to remove the glass panels.5Turn the two fasteners by 90° and remove them from their seats.6First lift carefully and then remove the glass panels one by one. Start from the top panel.7Clean the glass panels with water and soap. Drythe glass panels carefully.When the cleaning is completed, install the glasspanels and the oven door. Do the above steps inthe opposite sequence.Make sure that you put the glass panels (A and B)back in the correct sequence. The middle panel (B)has a decorative frame. The screen-printing zonemust face the inner side of the door. Make sure thatafter the installation the surface of the glass panelframe (B) on the screen-printing zones is not roughwhen you touch it.A BMake sure that you install the middle panel of glassin the seats correctly.REPLACING THE LAMPPut a cloth on the bottom of the interior of theappliance. It prevents damage to the lamp glasscover and the cavity.WARNING! Danger of electrocution!Disconnect the fuse before youreplace the lamp.The lamp and the lamp glass covercan be hot.CAUTION! Always hold the halogenlamp with a cloth to prevent greaseresidue from burning on the lamp.1. Deactivate the appliance.2. Remove the fuses from the fuse box ordeactivate the circuit breaker.20Downloaded from www.vandenborre.be