CAUTION! If there are otherappliances installed in the samecabinet, do not use them when thePyrolysis function operates. It cancause damage to the appliance.1. Remove the worst dirt manually.2. Clean the inner side of the door with hot water,so that the residues do not burn from the hotair.3. Set the Pyrolysis function. Refer to "Ovenfunctions".4. When flashes, press or to set thenecessary procedure:Option DescriptionP1 If the oven is notvery dirty. Time ofthe procedure: 1 h.P2 If you cannot easilyremove the dirt.Time of the proce-dure: 1 h 30 min.Press or turn the knob for the temperature tostart the procedure.You can use the End function to delay the start ofthe cleaning procedure.During the Pyrolysis the oven lamp is off.5. When the oven is at its set temperature, thedoor locks. The display shows the symboland the bars of the heat indicator until the doorunlocks.To stop Pyrolysis before it is completed, turnthe knob for the oven functions to the offposition.6. When Pyrolysis is completed, the displayshows the time of day. The oven door stayslocked.7. When the appliance is cool again, an acousticsignal sounds and the door unlocks.CLEANING REMINDERTo remind you that the Pyrolysis is necessary, PYRflashes in the display for 10 seconds after eachactivation and deactivation of the appliance.The cleaning reminder goes out:• after the end of the Pyrolysisfunction.• if you press and at the sametime while PYR flashes in thedisplay.CLEANING THE OVEN DOORThe oven door has four glass panels. You canremove the oven door and the internal glass panelsto clean them.The oven door can close if you try toremove the glass panels before youremove the oven door.CAUTION! Do not use the appliancewithout the glass panels.1. Open the door fully and hold the two doorhinges.2. Lift and turn the levers on the two hinges.21