Zenith H20H52DT Installation And Operating Manual

Locate the Antenna/Cable jack on theback of the HealthView TV.Connect the antenna wire that runs fromthe wall to this jack, according to one ofthe diagrams shown to the right.Remove the back of the optional remoteand put in two AA batteries.Plug in the TV. The HealthView TV isdesigned to operate on standardcurrent, 120-volt 60 Hertz AC. Do notattempt to operate it on DC Power.Go to page 11 to Auto Program the TV.Antenna Hook UpConnect an off-air antenna to the HealthView TV.TV BackFlat wire(300 ohm)Antenna300/75 ohmAdapterTV BackAntennaRF Coaxial Wire(75ohm)Back ofRemote12345If you have a 75 ohm RF cable, then youdon’t need any adapters.A 300 to 75 ohm adapter is not includedwith the HealthView TV.ZenithThe wire that comes from an off-air antenna or cable service provider. Each end lookslike a hex shaped nut with a wire sticking through the middle, and it screws onto thethreaded jack on the back of the TV.A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. Theyare usually about an inch long with two screws on one end and a round opening with awire sticking out on the other end.Mini Glossary75 OHM RFCABLE300 TO 75OHMADAPTERPage 6ANTENNACABLEM.P.I.TV Back Panel(Expanded View)PILLOW SPEAKERTV SPEAKERVIDEO IN SPEAKER OUTAUDIO INANTENNACABLEM.P.I.TV Back Panel(Expanded View)PILLOW SPEAKERTV SPEAKERVIDEO IN SPEAKER OUTAUDIO IN