14 Plasma TVInstallation- To avoid picture noise (interference), leave an adequate distance between the VCR and TV- Use the ISM Method (on the Option menu) feature to avoid having a fixed image remain on the screen for a long period of time.If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.Connection Option 1Set VCR output switch to channel 3 or 4 andthen tune the TV to the same channel number.Connection Option 21. Connect the audio and video cables from theVCR's output jacks to the TV input jacks, asshown in the figure.When connecting the TV to VCR, match thejack colors (Video = yellow, Audio Left = white,and Audio Right = red).If you connect an S-VIDEO output from VCR tothe S-VIDEO input, the picture quality isimproved; compared to connecting a regularVCR to the Video input.2. Insert a video tape into the VCR and pressPLAY on the VCR. (Refer to the VCR owner’smanual.)3. Select the input source with using theTV/VIDEO button on the remote control. Notethat this TV finds the connected input sourcesautomatically for Video, Front Video andComponent 1-2. It is presumed that RGB andHDMI/DVI sources are connected.Do not connect to both Video andS-Video at the same time.VCR SetupVCR SetupAUDIORLVIDEOCOMPONENT INPUT 1RL(MONO)DVD/DTVINPUTCOMPONENT INPUT 2MONITOR OUTPUTA/V INPUTVIDEO AUDIOS-VIDEOCABLEANTENNARGB/DVI AUDIOINPUTREMCONS-VIDEO OUTIN(R) AUDIO (L) VIDEO3 4OUTPUTSWITCHANT OUTANT INS-VIDEOVCR Rear1 2• To improve the picture quality in a poor signal area,please purchase a signal amplifier and install properly.• If the antenna needs to be split for two TV’s, install a “2-Way Signal Splitter” in the connections.• If the antenna is not installed properly, contact your deal-er for assistance.ANTENNASignalAmplifier3. Analog and Digital TV signals provided on cable and antennaAntennaRF Coaxial Wire (75 ohm)Bronze WireTurn clockwise to tighten.Cable TV WallJack RF Coaxial Wire (75 ohm) CABLEANTENNABronze Wire