Document: DateCreated By: ECO#LPN00370X0001A0_ATMT 009113INSTALLATION INSTRUCTIONSLED E-DD0L40 SERIES2018-4-24www.e-conolight.com | 888.243.9445 | FAX: 262.504.5409CAUTIONSIMPORTANT SAFEGUARDSWhen using electrical equipment, basic safetyprecautions should always be followed including thefollowing:READ AND FOLLOW ALL SAFETYINSTRUCTIONS1. DANGER- Risk of shock- Disconnect power beforeinstallation.DANGER – Risque de choc – Couper l’alimentationavant l’installation.2. SUITABLE FOR WET LOCATIONS.CONVIENT AUX EMPLACEMENTS MOUILLES.SAVE THESE INSTRUCTIONS FORFUTURE REFERENCEDIRECT MOUNTINGFIGURE 1FIGURE 2- Items Included with FixtureFIGURE 3- Photo-control InstallationE-DD0L SERIES-DIRECT MOUNTED1. Install fixture cover plate to conduit using either knockout.2. Use fixture to mark the location for the lag bolts onmounting surface.3. Install two lower lag bolts into mounting surface, allowingthe head of each bolt to remain 1/4” (6.4 mm) frommounting surface.4. Wire black fixture lead to the incoming voltage supplyor Hot 1 lead and the white fixture lead to the incomingneutral (Common) or Hot 2 lead. Attach bare copper orgreen ground fixture lead to the incoming ground lead.5. Slide fixture onto two lag bolts from Step 3 and install thirdlag bolt in top slot of fixture. Secure all lag bolts.6. Secure cover plate with (2) hex bolts. Discard arm bracket.7. Install the photo-control by aligning the arrow on the topof the photo-control with the arrow on the photo-controlsocket and inserting pins into the socket. Twist photo-control clockwise until the arrow on the photocontrol ispointing north. (Photocontrol must be rotated at least 1/8turn to properly lock in place). See Figure 3.NOTE: Improper installation of the photo-control may resultin damage to the photo-control.Hex BoltsLag BoltsCover PlateWire NutsArm BracketFixture