e-conolight E-RS Series Installation Instructions Manual

e-conolight E-RS Series Installation Instructions Manual Manual pdf 1 page image

Document: DateCreated By: DCR#LPN00320X0001A0_A 2015-12-22TMT 005842INSTALLATION INSTRUCTIONSLED Radial Wall SconceE-RS Serieswww.e-conolight.com | 888.243.9445 | FAX: 262.504.5409CAUTIONSIMPORTANT SAFEGUARDSWhen using electrical equipment, basic safetyprecautions should always be followed including thefollowing:READ AND FOLLOW ALLSAFETY INSTRUCTIONS1. DANGER- Risk of shock- Disconnect power beforeinstallation.DANGER – Risque de choc – Couper l’alimentationavant l’installation.2. This luminaire must be installed in accordance with theNEC or your local electrical code. If you are not familiarwith these codes and requirements, consult a qualifiedelectrician.Ce produit doit être installé conformément à NEC ou votrecode électrique local. Si vous n’êtes pas familier avec cescodes et ces exigences, veuillez contacter un électricienqualifié.3. Wall Mount Only.Installation Murale Seulement.SAVE THESE INSTRUCTIONSFOR FUTURE REFERENCE1. Remove the rear mounting plate by removing the (2) Phillips headscrews located on the lower flange of fixture. Do NOT pull cord outof grommet in mounting plate. See Figure 1.2. While supporting fixture and mounting plate, splice the powerleads from the cord to the branch circuit leads in the junction box.Attach black to black (hot), white to white (neutral) and green togreen (ground). Push the splices into the junction box. See Figure2.3. Remove only two appropriate plugs from the back plate formounting over the corresponding junction box. Leave all otherplugs in place.4. Attach the rear mounting plate to the junction box using suppliedscrews and o-rings. For wet locations, caulk between rear gasketand mounting surface to prevent water from entering junctionbox area. A high grade caulking material such as silicone rubbershould be used. See Figure 3.DIRECT MOUNTING TO JUNCTION BOXFIGURE 1Notes:1. Fixture is intended to operate at 120-277 VAC only.2. Fixture is intended to be mounted over 3 1/2" or 4" octagonrecessed junction box or 4" square junction box, supplied bycustomer.FIGURE 2FIGURE 3

/ 2

Related manuals for e-conolight E-RS Series