KERN KERN AEJ manuals
KERN AEJ
Table of contents
- Table Of Contents
- Technical Data
- Dimensions
- Declaration of conformity
- Appliance overview
- Keyboard overview
- Overview of display
- Basic Information (General)
- Basic Safety Precautions
- Unpacking and erection
- Connection of peripheral devices
- Initial Commissioning
- Simple weighing
- Net/gross
- Display speed
- Underfloor weighing
- Adjustment
- Adjustment with external weight (only AEJ)
- Adjustment with external weight (only AES)
- Advice CAL/Auto-CAL (KERN PEJ only)
- Standard deviation (KERN PEJ only)
- Verification switch and seals
- Navigation in menu 1
- Overview Menu 1
- Settings for density determination
- Settings for serial interface
- Navigation in menu 2
- Overview Menu 2
- Operating modes
- Weighing / Weighing unit change
- Percent determination
- Numeric entering of the reference weight
- Weighing with freely programmable weighing unit
- Density determination of solids (hydrostatic weighing)
- Adding of displayed values
- Add-up without AUTO-TARE
- Adding with AUTO-TARA
- Weighing with tolerance range
- Display of the results
- Enable function / settings in menu
- Tolerance control for absolute values
- Tolerance control for differential values
- How to set date/time
- Date
- Description of individual menu items
- Save tare value automatically (models AES only)
- How to enter ID number for weighing balance
- Data output
- Printer interface (unidirectional data exchange)
- Units
- Output weighing data in operating mode
- Output time
- External tare command
- Printer mode
- Printout examples
- Service, maintenance, disposal
- Error messages, troubleshooting guide
KERN AEJ
Table of contents
- Table Of Contents
- Basic information
- Total View
- Electric/Electronic Construction
- Whole Wiring
- Troubleshooting
- Troubleshooting Table
- Primary Check
- Check of Electric/Electronic Parts
- Adjustment and Setting
- Span Calibration (Adjustment with external weight – AES)
- Verification switch and seals
- Corner Error Adjustment
- Linearity Adjustment
- Linearity Adjustment of AES 220-4 and AEJ 220-4M
- Calibration of Built-In Weight (Ref Cal) – only AEJ
- Address Data Check and Re-setting
- Adjustment of Overload Stopper
- Parts Replacement
- The Sequence of HT-DP Board Replacement
- The Sequence of Mechanical Unit Replacement
- The Sequence of Tuning-Fork Sensor
- Parts List
- Bill of Material
- Appendix
manualsdatabase
Your AI-powered manual search engine