2gig Technologies Go!Control 2GIG-CNTRL2 User Manual

Also see for GO!control 2GIG-CNTRL2: Installation & programming instructions Operation and user's guide

Contents

2gig Technologies Go!Control 2GIG-CNTRL2 User Manual Manual pdf 30 page image

28User ManagementThe system installer has pre-programmed a Master User code for your system. This code can be usedto control the system, as well as assign and change the other 31 User Codes and User Code accessoptions. The Master User Code can also access several system setup settings in the User Toolbox.The other 31 User Codes are restricted from those settings in the User Toolbox.User Code SetupOnly the person with the Master User Code can add or change the other User Codes.To setup the User Codes, use the following steps:1. On the Home Screen, press SECURITY.2. On the Security Screen, press MENU.3. On the Menu Screen, press TOOLBOX.4. Enter the Master User Code(the factory setting is 1111).5. On the Toolbox Screen (1 of 3),press USER MANAGEMENT.6. The Users Management Screen displaysthree users at a time. Use the ↓ and↑ arrows to scroll through the list.Adding a User Code✓ NOTE: User Codes 0000 and 0001 arenot permitted.1. Press one of the ADD USER buttons.2. Enter a four-digit code for thenew User Code and press OK.3. Enter the Code again to confirmthe code and press OK.4. A confi rmation screen willdisplay, press OK.5. The User Code’s Access Option Screenwill be displayed. The three optionsdetermine when this User Code is valid.6. Select one of the three options:ALWAYS; NEVER; or BY SCHEDULE.• Select ALWAYS to set this UserCode to always be valid. Press BACK.• Select NEVER to set this User Codeto never be valid. Press BACK.• Select BY SCHEDULE set this UserCode to be valid only for selecteddays and times. See the next section.System ToolboxUser Management ScreenUser Code Entry ScreenUser Access Options ScreenToolbox Screen 1