Inserting the LAN+Modem Card 7When attaching connectors to the LAN+Modem card,insert them with the icon side up. Be sure to attach theconnector to the correct port. You cannot damage the cardusing the wrong port, but it will not operate if the cablesare mismatched.Inserting the LAN+Modem CardThese general instructions apply to most notebookcomputers. Refer to the manual that accompanied yourcomputer for instructions specific to your computer.To install the card, slide it into the PC Card slot, as shown inFigure 2-2. The power to the computer can be on or off.Without forcing the card, push until it seats firmly.Figure 3 Inserting the LAN+Modem CardCAUTION: Forcing the card into the slot may bend the pinsinside the slot. If you don’t know how to insert cards inyour computer, refer to the documentation supplied withyour computer on using PC Card (PCMCIA) slots.Do not pull the cable to disconnect the connector from thecard. This may damage the card and make it inoperable.Refer to the section “Disconnecting and Removing theLAN+Modem Card” on page 10 of this chapter.
